Filter
Top Products
23
Lubrication
The bearings on the cutterhead are factory
lubricated and sealed for life – no lubrication
required.
Gearbox – The oil in the gearbox must be
drained and replaced after the first 20 hours of
operation. (See the Lubrication Table).
Inspect levels periodically and change yearly.
Replace gear oil more frequently under heavy
use. Fill until the oil reaches the top of the filler
plug port for correct oil level.
Figure 39
To replace the gearbox lubricant:
1. Remove the drain plug (3. Fig. 39), and filler
cap (A, Fig. 40). Drain dirty oil thoroughly.
2. Tighten the drain plug (3, Fig. 39).
3. Fill with clean lubricant through hole
(A, Fig. 40).
Tighten filler cap (A, Fig. 40).
Figure 40
No Fig Position Interval Suitable Types of Lubricant
1 39 Drive Chain Inspect and lubricate monthly Grease
2 39 Gear Box
When operated more than
2,500 hours
HD-100, Mobil Gear 627, Shell Omala
100, ESSO Spartan EP-100
3 41 Lead Screw Inspect and lubricate Monthly Grease
4 41 Column Inspect and lubricate weekly SAE-30
5 42 Table Chain
Inspect monthly – lubricate
when needed
Grease or good quality bicycle chain
lubricant
6 43 Feed Rollers
Inspect and lubricate daily
before startup
SAE-30
Lubrication Table