Filter
Top Products
8
Receiving
Carefully unpack the planer and any loose items
from the wood crate and inspect for damage.
Any damage should be reported immediately to
your distributor and shipping agent. Before
proceeding further, read your manual thoroughly
to familiarize yourself with proper assembly,
maintenance and safety procedures.
Remove the protective coating from the table,
bed rolls, feed rolls, cutterhead and loose items
packed with the machine, including lifting
handles and motor pulley. This coating may be
removed with a soft cloth moistened with
Kerosene. Do not use acetone, gasoline or
lacquer thinner for this purpose. Do not use
solvents on plastic parts.
Parts Inventory
Parts requiring assembly:
1 Planer Unit
1 4" Dust Hood
2 In/Outfeed Extension Roller Assembly
1 Handwheel
Cast Foot Assembly:
4 Cast Feet
1 Hardware Bag, consisting of:
8 Socket Head Flat Screws
8 Flat Washers
8 Hex Nuts
Stand Assembly:
4 Stand Legs
2 Stand Braces – long
2 Stand Braces – short
2 Stand Top – front & rear
1 Stand Top – left
1 Stand Top – right
1 Hardware Bag, consisting of:
32 Carriage Bolts
32 Flat Washers
32 Hex Nuts
Accessory Package:
1 Handle
2 Knife Gauges
1 Knife Setting Gauge Bar
4 E-Rings for Knife Setting Gauge
4 Hex Wrenches – 3, 4, 5, 6mm
2 Open Wrenches – 8/10mm, 12/14mm
Hardware Bag for Handwheel:
1 M10 Hex Nut
1 M10 Flat Washer
1 Direction Label
Hardware Bag for Infeed/Outfeed Extension
Rollers
6 M8 x 20 Hex Head Screws
6 M8 x 12 Set Screws
6 M8 Flat Washers
Hardware Bag for Dust Hood:
6 M6 x 12 Hex Head Screws
Hardware Bag for Base to Stand:
4 M8 x 30 Hex Head Screws
4 M8 Hex Nuts
8 M8 Flat Washers