Filter
Top Products
9. Grasp the feed handles and rotate them toward the front of the drill press low-
ering the drill bit onto the workpiece. This step is necessary to ensure the hole
will be where it is intended. Make any adjustments necessary.
10.Plug the drill press power cord into the AC power source. Insert the YELLOW
key into the ON/OFF switch.
ADJUSTING THE TABLE HEIGHT
Turn the drill press ON/OFF switch to the OFF position
and disconnect the AC power to prevent drill press from accidentally
turning on.
1. Loosen the table lock handle.
2. Turn the table crank handle counter-
clockwise to lower the worktable and
clockwise to raise it.
3. Adjust the worktable to the desired
height.
4. Securely lock the table lock handle.
5. Apply the AC power and turn the
ON/OFF switch to the “ON” position.
Operate the drill press to ensure the
worktable is properly adjusted.
ADJUSTING THE TABLE TILT
Turn the drill press ON/OFF switch to the OFF position and
disconnect the AC power to prevent drill press from accidentally turning on.
1. Using a 3mm hex wrench, loosen the setscrew under the table bevel lock.
2. Using an adjustable wrench or a 24mm socket, loosen the table bevel lock.
3. Rotate the table to the desired tilt. Use the pointer and the bevel scale on the
table mount to set the table tilt.
26
INSERTING THE DRILL BIT
Do not apply AC power at this time. Preliminary steps
must be completed before turning on power to prevent damage to the work-
piece and lessen the probability of injuries to the operator.
Never try to hold the workpiece with just your hands.
This could the cutting tool to bind in the workpiece causing it to violently spin
resulting in damage to the drill press and injury to the operator.
1. Place the workpiece on the table.
2. Using a vise or clamps, secure the
workpiece to the table.
3. Loosen the table support lock and
turn the table crank counter-clock-
wise to lower the table away from
the drill chuck.
4. Turn the adjustment sleeve on the
drill chuck counter-clockwise to
open the jaws and clockwise to
close them.
5. Insert a drill bit into the drill chuck.
Tighten the jaws around the drill bit
by turning the adjustment key. Insert
the chuck key into each hole on the
drill chuck to tighten each jaw
securely against the drill bit.
6. Loosen the table support lock
and turn the table crank clockwise to raise the table and counter-clockwise to
lower the table.
DO NOT use drill bits that are over 6" inches long in this
drill press. Longer drill bits are more prone to break than the shorter bits
when pressure is exerted with the feed handles.
7. Set the table height so that the tip of the drill bit will reach the desired depth.
8. Lock the table support lock by turning it clockwise.
25
FIGURE 18. INSERTING THE DRILL BIT
FIGURE 19. ADJUSTING THE TABLE HEIGHT