Filter
Top Products
SPECIFICATIONS
SPECIFICATIONS
Voltage 120V 60 Hz
Rated Current 7.8 A
No-Load Speed (motor) 1700 RPM
Max. Distance
From Spindle Axis
To Surface Of Column: 7 3/4" (197mm)
Max. Distance
From Spindle End
To Surface Of Table: 26 1/8" (664mm)
Spindle Travel: 3 3/8" (86mm)
Chuck Capacity 5/8" (16mm)
Range of Spindle Speeds 240-3200 RPM
Laser Beam Class II, Diode Laser
Average Radiant Power 1mw
Laser Beam Wavelength 650nm
OTHER CONSUMER DO-IT-YOURSELF (DIY) TOOLS
Alltrade offers a full range of Kawasaki™ tools that make DIY jobs easy. If you would
like further information on the following products, please contact Alltrade Customer
Service Department at 1-800-590-3723.
Cordless Drills/Screwdrivers
Impact Wrenches
Sanders
Jigsaws
Circular Saws
Angle Grinders
Reciprocating Saws
Routers
Rotary Tools
Corded and Cordless Multi-Purpose Tools
Wide Range of Accessories and more
34
TROUBLESHOOTING
To avoid any accidental starting of the Drill Press, turn
the switch to the “OFF” position, remove the safety key, and unplug the tool
from the AC power source.
Should the motor fail to run, for any reason, call Alltrade Customer Service.
ACCESSORIES
Optional accessories for the drill press can include wire-brush wheels that can be
used for cleaning and layered cloth wheels that can be used for polishing and buff-
ing. Contact ALLTRADE Customer Service at 1-800-590-3723 (toll free) to find out
what accessories are available for the drill press.
Only use accessories that are designed to fit your partic-
ular drill press. These accessories should be specifically labeled to match
the speed and arbor size of the drill. Failure to use the proper accessories
could result in property damage, damage to the drill and serious personal
injury to the operator.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.
If the drill press must be used outside, use an extension cord labeled “W-A” or
“W.” These extension cords are rated for outdoor use and reduce the chances of
electrical shock.
If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may experi-
ence a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord (see table below).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING CONDUCTOR SIZE IN A.W.G
AMPERE 10FT. 25FT. 50FT. 100FT.
3-6 18 18 18 18
6-8 18 18 18 16
8-10 18 18 18 14
10-12 16 16 14 14
12-16 14 12 12 -
16-20 12 12 12 -
33