Filter
Top Products
#$&(#"
+ "#"(&# ' 86DA4
#)($)(#"(&# The OUTPUT dial is
used to preset the output voltage or current as dis-
played on the digital meters for the five welding
modes. When in the CC-STICK, ARC GOUGING or
CV-WIRE modes and when a remote control is con-
nected to the 6-Pin or 14-Pin Connector, the auto-
sensing circuit automatically switches the OUTPUT
CONTROL from control at the welder to the remote
control.
When in the DOWNHILL PIPE mode and when a
remote control is connected to the 6-Pin or 14-Pin
connector, the output control is used to set the max-
imum current range of the remote.
,!$ When the OUTPUT CONTROL on the
welder is set to 200 amps the current range on the
remote control will be 40-200 amps, rather than the
full 40-300 amps. Any current range that is less than
the full range provides finer current resolution for
more fine tuning of the output.
In the CV-WIRE mode, if the feeder being used has
a voltage control when the wire feeder control cable
is connected to the 14-Pin Connector, the auto-
sensing circuit automatically makes OUTPUT CON-
TROL inactive and the wire feeder voltage control
active. Otherwise, the OUTPUT CONTROL is used
to preset the voltage
When in the TOUCH START TIG mode and when
an Amptrol is connected to the 6-Pin Connector, the
OUTPUT dial is used to set the maximum current
range of the CURRENT CONTROL of the Amptrol.
( #)($)( !(&'
The digital
meters allow the output voltage (CV-WIRE mode)
or current (CC-STICK, DOWNHILL PIPE, ARC
GOUGING and TIG modes) to be set prior to weld-
ing using the OUTPUT control dial. During welding,
the meter display the actual output voltage
(VOLTS) and current (AMPS). A memory feature
holds the display of both meters on for seven sec-
onds after welding is stopped. This allows the oper-
ator to read the actual current and voltage just prior
to when welding was ceased.
While the display is being held the left-most deci-
mal point in each display will be flashing. The
accuracy of the meters is +/- 3%.
+ !#' (#&'+(
(Provides five selectable welding modes)
CV-WIRE
ARC GOUGING
DOWNHILL PIPE
CC-STICK
TOUCH START TIG
)&
&*"(P)#(
111
1
2
9
1
7
3
4
18
2
0
19
16
13
1
4
12
24
6
5
8
7
22
21
11
10
15
25
31
27
28
26
111
1
2
9
1
7
3
4
18
2
0
19
16
13
1
4
12
24
6
5
8
7
22
21
11
10
15
25
31
27
28
26