Filter
Top Products
B-2
OPERATION
B-2
REAR CONTROL PANEL (FIGURE B.1)
• I1: Off/On switch turns on the electric power to
the welder. It has two positions, "O" off, and
"I" on.
------------------------------------------------------------------------
* With "l1" in the "I" (ON) position, the welding
machine is operational and there is voltage between
the positive (+) and negative (-) Terminals in stick
welding. In TIG, the welding process needs a trigger
closure command at the remote control connec-
tion.(Usually via an Arc Start Switch or Foot Amptrol)
* The welder is connected to the supply even if the “l1”
(Power Switch) is in the "O" (Off) position, and there-
fore there are electrically live parts inside the power
source. Carefully follow the instructions given in this
manual.
FIGURE B.1
* 1 : Supply cable
* 2 : Gas attachment
l1 : Power Switch
V205-T DC & V205-T AC/DC TIG
WARNING