Filter
Top Products
P 4/10
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Base Complete (cont.)
Shoulder pin 6-7
Base complete, viewed from bottom
Hex socket set screw M5x8
(a), (b): for securing Shoulder pin 6-7
(c): for fine adjustment of the angle of Base to Saw blade
Angular guideDepth guide
Shoulder pin 6-7
Fig. 8 Fig. 9
Base complete
Angular guide
Motor section
4) Unscrew two M5x8 Hex socket set screws that secure 6-7 Shoulder pins. (Fig. 8)
Note: Do not unscrew the M5x8 Hex socket set screw used for fine adjustment of the angle of Base to Saw blade
in this step.
5) Remove two 6-7 Shoulder pins. Base complete can now be separated from Motor section. (Fig. 9)
DISASSEMBLING
(a) (b)
(c)
Base complete
ASSEMBLING
Do the reverse of the disassembling steps.
Note: Bow stop ring E-12 is not reversible when assembled to Lever 56.
Be sure to assemble it in place as described in Fig. 10.
Fig. 10
Hex nut M8-13
Bow stop ring E-12
The concave side of Bow stop ring E-12
must be positioned on Motor housing side.
concave side
(Motor housing side)
Lever 56
Lever 56
Hex nut M8-13
Bow stop ring E-12
Motor housing
[A]
Bow stop ring E-12 viewed from [A]