Filter
Top Products
P 8/10
Repair
The angle of Saw blade to Base plate is adjusted to 90 degrees in factory.
But if out of adjustment, apply a triangular rule or 1R208 to Saw blade
and Base plate, then turn Hex socket set screw M5x8 with Hex wrench 2.5
until Saw blade is square to Base plate. (Fig. 29)
[3] -6. Replacing the Electrical Parts in Handle Section
Remove Handle cover by unscrewing four 4x18 Tapping
screws on Motor housing section. (Fig. 28)
Electrical parts in Handle section can now be replaced.
Handle cover
Motor housing section
Fig. 28
Tapping screw 4x18 (4 pcs)
30 degrees
Fig. 30 Fig. 31
30 degrees
[4] ADJUSTMENT
Note: Be sure to unplug the tool before making the following adjustments.
[4] -1. Squaring Adjustment of Saw Blade
Each of the two Lever 56's (the one used for bevel angle adjustment and the one used for cut depth setting)
must be fixed in place so that it can be locked at an angle of between 0 and 30 degrees as illustrated in Figs. 30, 31.
[4] -2. Adjustment of Two Lever 56's
Fig. 29
Hex wrench 2.5
triangular rule (or 1R208)
Hex socket set screw M5x8
Base plate
Lever 56
(the one used for
bevel angle adjustment)
Lever 56
(the one used for
cut depth setting)
Base plate
Base plate