Filter
Top Products
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Magazine (cont.)
P 12/ 15
Repair
Points of ASSEMBLING
Fig. 52
Fig. 50
Fig. 51
Lever
Upper rail
complete
Slide door
cap
• Be sure to check that Nail stoppers work properly as drawn in Figs. 50 and 51.
• When installing Slide door cap into Upper rail complete,
press Slide door cap fully in the direction of an arrow drawn in
Fig. 52 and tighten M4x10 Pan head screw at the same time.
• While facing the slot of Shoulder pin 5-7 to the magazine side
as drawn in Fig. 45, install Pusher to Upper rail complete.
Nail guide holder
Pusher
Nail guide holder
Any Nail stoppers must not be stuck in the groove of Nail guide holder.
Check if all Nail stoppers come back to original position with spring tension
when you release Nail guide holder.
When pushing down Nail guide holder against workbench and
pressing the designated points of Nail stoppers, Nail stoppers
have to be returned back without any interferes.
If Leaf spring under Nail stoppers is not completely seated on
the bottom, some Nail stoppers are caught in the bottom side.
When the above trouble happens, pull and return the nail stoppers
several times, and then find out the nail stoppers’ smoothest
position.
When Nail guide holder
is pushed into Magazine,
Nail stoppers rise to
Pusher side.
Action of Nail guide holder
Pressure to Nail guide holder
Nail stoppers are
in Nail guide holder.
Pusher
Workbench