Filter
Top Products
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Spring Section (cont.)
Guide bolt
Wrench 8
M6 Hex nut
Holder
Flat washer 6
Rail
Guide bolt
Cushion
Cushion
Cushion is fit into the groove of
Guide bolt firmly. Therefore, twist
Cushion to pull it off from the groove.
Turn compression spring 17 counterclockwise
while holding Spring holder with gloved
hands.
Spring holders is removed from Compression
spring 17.
After removing Guide bolt and Flat washer 8, remove Spring
holder of the opposite side in the same way drawn in Fig. 21.
Note: When inserting Spring holder into Compression spring 17,
turn Compression spring 17 clockwise and twist Spring
holder to set in place.
Turn guide bolt counterclockwise
while gripping holder by a gloved
hand and remove M6 hex nut,
Holder with Rail and
Flat washer 6 from Guide bolt.
Hammer
Fig. 19 Fig. 20
Fig. 21 Fig. 22
Fig. 23
Spring holder
Spring holder
Compression
spring 17
Flat washer 8
Guide bolt
(3) Disassemble the Spring section in order of Fig. 19, 22. Spring section is removed as drawn in Fig. 23.
M6 Hex. nut
Holder
Spring holder
Rail Cushion
Hammer
Flat washer 6
Flat washer 8
Spring holder Guide bolt
Compression spring 17
DISASSEMBLING
Repair
P 6/ 15