Filter
Top Products
IO.
For Corner Joint only
Place the tool on the workpiece
so
that
the blade is facing down.
For T-Butt Joint only
Remove the angle guide from the tool.
Place the tool on the workpiece
so
that
the blade is facing down.
11.
Repeat the steps
6
-
8
to cut the slots in the horizontal or the other workpiece.
.
If you do not need to center the blade in the board thickness, proceed as follows:
For Corner Joint, Miter Joint, Frame Joint and Edge-To-Edge Joint only
i
1
Remove the angle guide from the
tool.
Set the fence at
90°
for Corner Joint,
Frame Joint and Edge-To-Edge Joint or
at
45O
for Miter Joint.
i i
)
Follow steps
1
-
11
excluding steps
5
and
10
described above.
10