Filter
Top Products
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source
with
voltage greater than that specified
for the tool can result
in
SERIOUS INJURY to the user
-
as well as damage to
the tool. If in doubt,
DO
NOT PLUG IN
THE
TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1.
Use only the blades specified for this tool. This is extremely important for
2.
Never operate the tool with the blade locked
in
exposed position or without
3.
Make sure that the blade slides smoothly before operation.
4.
Check the blade for cracks or damage before operation. Replace cracked
5.
Make sure that the flange fits
in
the arbor hole when installing the blade.
6.
Inspect for and remove all nails or foreign matter from the workpieces be-
7.
Always place the workpiece on a stable workbench.
8.
Secure the workpiece firmly
with
clamp or vise.
9.
Never wear gloves during operation.
IO.
Hold the tool firmly with both hands.
11.
Keep your hands and body away from the cutting area.
12.
Run
the
tool
for
a
while without the blade pointing toward anybody. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
13.
Never reach your hands underneath the workpieces while the blade is
rotating.
14.
Do
not leave the tool running unattended.
15.
Always be sure that the tool is switched off and unplugged before making
your personal safety.
the blade cover secured properly
in
place.
or damaged blade immediately.
fore operation.
any adjustments.
SAVE THESE INSTRUCTIONS.
4