Filter
Top Products
For T-Butt Joint only
i
)
Fit the two workpieces together as they will appear in the finished joint position.
i i)
Lay the vertical workpiece on the horizontal one. Clamp both workpieces to the work-
bench as shown in the figure.
i
i
i
)
Remove the angle guide from the tool.
i
v
)
Follow the steps
2,
4,
6,
7,
8
and
1 1
described above.
F-
How
to trim
wall
or ceiling panels
First unplug the tool. Open the blade cover and replace the existing cutter blade with an
optional circular saw blade
110
mm
(4-3/8")
in
diameter. Refer
to
the "Removing or installing
the blade" section which
is
described later. Remove the rubber facing from the base. Then
close and secure the blade cover. Now the max. depth of cut is
25
mm
(1").
CAUTIO N
:
Be very careful that the blade has been properly mounted on the tool spindle between the
inner flange and the lock
nut.
Be sure to securely tighten the lock
nut.
Lock
nut
@
Blade
cover
Set the depth of cut to "MAX". Rest the base on the floor (when trimming the wall panels)
or the wall (when trimming the ceiling panels). Using the floor or wall as a guide, trim wall
or ceiling panels. Feed
in
;he direction of the arrow.
11