Filter
Top Products
3.
For Corner Joint and T-Butt Joint only
Clamp the vertical workpiece to the
workbench.
For Miter Joint only
Clamp one workpiece to the workbench
with the mitered edge facing up.
For Frame Joint and Edge-To-Edge Joint only
~
Clamp one workpiece to the workbench.
For
Frame
Joint
For
Edge-To-Edge-Joint
-\
4.
Set the depth
of
cut according to the size of biscuit to be used. Refer to the table in
5.
Adjust the angle guide height
so
that the blade is centered in the board thickness.
the “Adjusting the depth
of
cut” section.
8