Filter
Top Products
CAUTl
ON:
Before trimming the panels, check the wall or ceiling carefully to avoid cutting the electrical
wires, nails or other foreign materials.
*Always reinstall the rubber facing after trimming the panels. If cutting slots for biscuits
without the rubber facing installed properly on the
tool,
the tool might slip unexpectedly
on the workpiece, causing dangerous
loss
of control of the tool. When installing the rubber
facing, always hook
it
onto the inside of the front opening.
Removing
or
installing the blade
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the blade.
To
remove the blade, loosen the clamp screw
and open the blade cover. Push the shaft lock
and loosen the lock nut using the lock nut
wrench.
To install the blade, first mount the inner
flange.
CAUTION:
When installing the cutter blade, mount the
inner flange with the side marked
“22”
facing toward you.
When installing the circular saw blade,
mount the inner flange with the side
marked
“22“
facing toward the tool.
Lock
nut
-@
Cutter
blade
Inner
flange
Blade
coyer
Then mount the blade and the lock nut. Securely tighten the lock nut using the lock nut
wrench. Close the blade cover and tighten the clamp screw to secure the blade cover.
CAUTl ON:
*Use only the Makita lock nut wrench provided to remove or install the blade.
*Always check the depth of cut after replacing the blade. Readjust
it
if necessary.
12