Filter
Top Products
Fence
The angle of the fence can be adjusted between
0’
and
90’
(positive stops at
Oo,
45’
and
goo).
To
adjust the angle, loosen the lock lever and
tilt
the fence until the pointer
points to the desired graduation on the angle scale. Then tighten the lock lever to secure
the fence. When the fence is set at
90°,
both the distance from the center of the blade
thickness to the fence and the distance from the center of the blade thickness to the
bottom of the base are
10
mm
(0.4”).
Fence Lock lever
I
Anale scale
I
Pointe!
Lock lever
/ll--l
10
mm
(0.4”)
Center
of
blade thickness
Set plate
Use the set plate as shown below when cutting slots in thin workpieces.
Lock lever
Pointer,
/
11-
1
Set plate
set plate:
base
Center
of
blade thickness
Switch action
To
start the tool, slide the switch lever
toward the “ON” position.
To
stop the tool, simply depress the “OFF
side
of
the switch lever.
The switch lever will return
to
the “OFF
position.
Set
pl
Switch lever
i=-:il
/
CAUTION:
I
Before plugging in the tool, always check
to
see that the switch actuates properly and
returns
to
the “OFF position when the “OFF side
of
the switch lever is depressed.
If
not, then have it repaired by a qualified repair facility before use.
6