Filter
Top Products
14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
130
3006
VALUE EXCESS H, D, P If in tool offset selection (H) or (D) the
number entered under the address exceeds
the range permitted.
The same error occurs in case of value P
of command G10 L(10, 11, 12, 13).
The message is can-
celed by RESET
key.
3007
G43, G44, H IN G2, G3 If in a block containing circular interpola-
tion (G2, G3) tool length offset is pro-
grammed (G43, G44, H)
The message is can-
celed by RESET
key.
3008
ERRONEOUS G45...G48 If radius compensation code (D) is chang-
ed when using G45...G48 or
the use of code G45...G48 results in con-
flict.
The message is can-
celed by RESET
key.
3009
G45...G48 IN G41, G42 If code G45...G48 is used when G41 or
G42 is switched on.
The message is can-
celed by RESET
key.
3010
PLANE SELECT. IN G41,
G42
If plane selection (G17, G18, or G19) is
programmed in offset mode (G41, G42).
The message is can-
celed by RESET
key.
3011
RADIUS DIFFERENCE If the difference between the start point
radius and the end point radius of a circu-
lar arc exceeds the value specified in pa-
rameter 1021 RADDIF.
The message is can-
celed by RESET
key.
3012
ERRONEOUS CIRCLE
DEF. R
If in circular interpolation definition (G2,
G3) radius (R) had been specified and the
start point and end point coincide.
The message is can-
celed by RESET
key.
3013
MULTITURN CIRCLE
FAILURE
If at multiturn circle definition (polar
coordinate specification G16 is on) the
polar angle change is
not negative in case of G2 or
not positive in case of G3.
The message is can-
celed by RESET
key.
3014
ERRONEOUS CIRCLE
DEF.
If when programming circular interpola-
tion (G2, G3) neither the radius (R) nor
the center coordinate (I, J, K) is defined,
or
the specification of center coordinates
conflicts with the selected plane (G17: I,
J; G18: I, K; G19: J,K).
The message is can-
celed by RESET
key.
3015
3016
FORBIDDEN ADDRESS If an address has been referred to in the
program that is forbidden or conflicting in
that situation.
The message is can-
celed by RESET
key.
3017
,C AND ,R IN ONE BLOCK If chamfering (,C) and corner round (,R)
have been programmed in the same block.
The message is can-
celed by RESET
key.