Filter
Top Products
14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
131
3018
,A IN G2, G3 If in circular interpolation block (G2, G3)
angle (,A) has been programmed.
The message is can-
celed by RESET
key.
3019
DOMINATOR CON-
STANT=0
If in 3D radius compensation calculation
the value of dominator constant is 0.
The message is can-
celed by RESET
key.
3020
DATA DEFINITION ER-
ROR G33,G34
If in block G33, G34
more than 2 axes have been programmed,
or
both E and F are filled out, or
the thread lead is 0, or
,C or ,R has been programmed.
The message is can-
celed by RESET
key.
3021
G51 IN G33 If in block G33 scaling (G51) is on. The message is can-
celed by RESET
key.
3022
DIVIDE BY 0 IN G33 If G33 has been programmed and
value E is less than or equal with 0, or
the pulse number of spindle encoder on
parameter 5023 ENCODERS1 is 0.
The message is can-
celed by RESET
key.
3023
DATA DEFINITION ER-
ROR G26
In block G26 an address not interpreted
has been specified or there is a value
specification error at an interpreted ad-
dress.
The message is can-
celed by RESET
key.
3024
ERRONEOUS P VALUE IN
G96
If in block G96 (programming constant
surface speed) value P is not 1...9.
The message is can-
celed by RESET
key.
3025
DEFINITION ERROR S If programmed spindle revolution (S) is
greater than 65000 or
negative or
in canned cycles G84.2, G84.3 equals to
0.
The message is can-
celed by RESET
key.
3026
DEFINITION ERROR G10
L3
If in block G10 L3 (filling up the life time
table) P or L are in one block under ad-
dress T, H or D or other address was pro-
grammed.
The message is can-
celed by RESET
key.
3027
DEFINIT. ERROR T IN
G10 L3
If in block G10 L3 (filling up the life time
table) address T is defined without a
group being referred to.
The message is can-
celed by RESET
key.
3028
MORE TOOLS IN G10 L3 If in block G10 L3 (filling up life time ta-
ble) the number of tools within a group
exceeds the maximum value registered on
parameter 1181 GROUPNUM.
The message is can-
celed by RESET
key.