Filter
Top Products
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the vinyl bag.
¼ License plate bracket
¼ J-nut x 2
¼ Screw x 2
¼ Screw grommet x 2
1. Temporarily place the license plate bracket
while aligning points
k
A
of the front bumper
fascia with holes
k
B
in the license plate
bracket.
2. Remove the license plate bracket.
3. Carefully drill two shallow pilot holes
k
A
using a 0.39 in (10 mm) drill bit at the marked
locations. (Be sure that the drill only goes
through the fascia, or damage to the nut
may occur.)
4. Insert grommets into the hole on the fascia.
5. Insert a flat-blade screwdriver into the grom-
met hole to add 90° turn onto the part
k
C
.
6. Insert a J-nut into the license plate bracket
before placing the license plate bracket on
the fascia.
7. Install the license plate bracket with screws.
STI0446
INSTALLING FRONT LICENSE
PLATE
Technical and consumer information 9-13
੬ 06.7.20/Z33-D/V5.0 ੭