Filter
Top Products
MOUNTING
• The FX Series Inverter/Charger is approved for indoor or enclosed protected mounting only.
• An FX weighs approximately 62 lbs and must be secured with appropriate fasteners to a sturdy
mounting surface capable of supporting its weight. It is easier for two people to install the FX due to
its weight.
• OutBack FXs can be mounted in any position, but they perform better in locations oering plenty of
air circulation.
• Due to the variance in other mounting methods, OutBack only endorses the use of FLEXware or
previous versions of its mounting plate for installing the FX and associated system components
using M6 X 20mm machine screws (stainless steel for FLEXware and self-tapping for older mounting
plates), one per corner. Follow the instruction manual that comes with each mounting system.
• If mounting the FX on other surfaces such as plywood, wall studs, or masonry, use appropriate
fasteners to support approximately its weight. OutBack cannot be responsible for damage to the FX
if it is attached with inadequate fasteners.
• Install and secure each FX before attaching any wiring.
21”
Weight is approximately 62 pounds
8.25”
9
Insert appropriate fasteners at all
four corner openings