Filter
Top Products
30
NOTE: This is the maximum continuous DC current that the FX will draw from the batteries when inverting.
FX2012(M)T 190 ADC (ADC = Amps DC)
FX2524(M)T 95 ADC
FX2532(M)T 90 ADC
FX3048T 60 ADC
VFX2812(M) 265 ADC
VFX3524(M) 170 ADC
VFX3232(M) 115 ADC
VFX3648 85 ADC
AC INPUT OPERATING VOLTAGE RANGE
NOTE: This is the recommended AC input voltage range to be supplied to the FX. Voltages outside of
this range may damage AC loads connected to the FXs AC output terminals.
All FX Series Inverter/Chargers 90 – 150 VAC (VAC = volts AC)
MAXIMUM AC INPUT CURRENT
An AC input source connected to the FX supplies power for two separate internal AC circuits – the AC
transfer switch and the battery charging system. The AC transfer switch transfers the AC input power
to the AC loads. The FX’s battery charger will “back o” if the total AC loads—including the charger—
exceed the AC input current limit (default setting is 28 AAC). This “Input Limit” can be adjusted using
the MATE to avoid overloading a generator or trip a circuit breaker. If your generator cannot produce
28 AAC or you are connecting to an AC input source that has a breaker that is rated for less than 30
AAC, please refer to the FX and VFX Series Inverter/Charger Programming Manual to change this
setting.
All “Mobile” FXs 30 AAC per FX (AAC = Amps AC)
All 120 VAC FXs 60 AAC per FX (AAC = Amps AC)
MAXIMUM CURRENT FOR BATTERY CHARGER
Due to heat restraints, the FX limits incoming AC current to recharge the battery. Please refer to the FX
and VFX Series Inverter/Charger Programming Manual to adjust this setting. The battery charger has
an eciency of 90%. Other factors, such as cable losses, might reduce this eciency.
RATED DC INPUT CURRENT