Outback Power Systems FX 2024 T Welding System User Manual


 
Welcome to the OutBack Power Systems FX Series Inverter/Charger System
The FX Series Inverter/Charger oers a complete power conversion system—DC to AC, battery
charging, and an AC transfer switch—and can be used as a stand-alone or back-up application. It is
designed for indoor or enclosed locations.
OutBack Power Systems does everything possible to assure the components you purchase will
function properly and safely when installed as instructed according to local and national electrical
codes (NEC). Please read all of the following instructions and the instructions that come with any
other OutBack components that make up your power system. Further instructions on individual FX set-
ups as well as systems assemblies are included with the FLEXware manuals.
• The non-Mobile FX is ETL listed to UL1741 (Inverters, Converters, Controllers, and Interconnection
System Equipment for Use with Distributed Energy Resources)
• All Mobile FX Series Inverter/Chargers are ETL listed to UL 458.
The FX and VFX Series Inverter/Charger Installation Manual covers the following information:
Safety
FX parts, standard and optional
• Initial inspection of the component
Preparing the mounting surface
Fastening the FX to the mounting surface
General electrical information
FX Series Inverter/Charger Models
Sealed Units (designed for harsher environments, but still require overhead and sidewall protection)
FX 2012 T (12 VDC/2000 VA)
FX 2024 T (24 VDC/2000 VA)
FX 3048 T (48 VDC/3000 VA)
Vented Units (designed for more protected environments)
VFX 2812 (12 VDC/2800 VA)
VFX 3524 (24 VDC/3500VA)
VFX 3648 (48 VDC/3600VA)
Each model FX has a single phase output marked with this symbol:
Each inverter puts out a sine wave waveform marked with this symbol:
Parts Included
One FX Series Inverter/Charger
One “WARNING ELECTRICAL SHOCK” sticker to place on the exterior of the FX
One packet of silicone grease to protect CAT 5 cable connections
One installation manual
One programming manual
One Turbo Kit (sealed units)
One DC Wiring Cover or DCC (vented units)
2