Filter
Top Products
11
Figure 6
Figure 7 – Stand hardware package (64B-SHP)
8.2 Unpacking and cleanup
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Table Saw is assembled
and running properly.
Compare the contents of your container with the
previous list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
Tools required for assembly (provided):
10, 12, 14 and 17 mm wrenches
Hex key set
Arbor wrench
Additional tools required (not supplied):
Cross point screwdriver
Rubber mallet or dead-blow hammer (or steel
hammer over a block of wood)