Filter
Top Products
14
8.6 Installing table extensions
Refer to Figure 10.
Figure 10
1. Attach a table extension to the saw table.
Make sure edge bevel on table extension
faces front, to match that of saw table. Use
three screws, lock washers and flat washers
(HP-1/2/3). Lightly snug screws with 17mm
wrench.
Assembly Tip: If you are doing this without an
assistant, lift table extension vertically to the
table edge. Install center screw and washer,
and make snug. Then pivot the extension
parallel to saw table to insert the other two
screws.
2. Repeat for opposite table extension. Lightly
snug screws.
3. The front edge of table extensions must be
flush with front edge of saw table. If needed,
tap front edge of extension with a rubber
mallet to make flush. See Figure 11.
Figure 11
8.7 Leveling table extensions
Refer to Figure 12.
Level table extensions to saw table using a straight
edge. A metal straight edge is ideal, though a
carefully jointed board may also be used.
Figure 12
1. Start by tightening the three screws (17mm
wrench) under the table extension that secure
it to the saw table. Tighten these just enough
to hold the extension in place but loose
enough to change the extension height by
tapping on it.
2. Lay the straight edge (A, Figure 12) across the
saw table and extension, extending it out past
the edge of the extension as shown.
3. Move the straight edge to several places along
the table extension, as you continue to nudge
the extension level with the saw table. When
extension is level with saw table, securely
tighten each of the three screws.
4. Repeat steps 1 through 3 for opposite table
extension.
8.8 Rails and Fence
With table extensions properly aligned, the rails
and Accu-Fence
®
assembly can now be mounted
to the saw. Consult the manual, no. M-2195075Z,
that accompanies the fence.
NOTE: The two tapped holes at the ends of the
table extensions are not used. There may be
additional holes in the table’s edge that are not
required for this rail installation.
8.9 Wood Extension Table
For instructions on mounting the accessory wood
extension table, consult your Accu-Fence®
manual, document no. M-2195075Z.