Filter
Top Products
13
Figure 9
8.4 Mounting saw to stand
Refer to Figure 9
The table saw is heavy! Get
persons to assist you in lifting it. Failure to
comply may result in serious personal injury
and/or damage to the machine.
1. Carefully lift table saw out of carton.
2. Place table saw atop the stand, orienting the
motor in the cut-out of the stand, and aligning
the four holes on its bottom edge with those in
the stand.
3. Insert four screws, with flat washers, lock
washers and hex nuts (SHP-1/4/5/6), as
shown.
4. Securely tighten all four hex nuts (SHP-6),
using a 12mm wrench and an additional
wrench to hold the screw steady while
tightening the nut. (NOTE: If you need more
room to wrench the back screws, follow
instructions below for tilting motor out of the
way.)
5. Finish tightening all fasteners in the stand.
8.5 Installing handwheels/hooks
Refer to Figure 9.
1. Install a handwheel onto the tilting and raising
shafts, as shown. Fit the slot of the handwheel
onto the roll pin on the shaft, then secure by
screwing on the locking knob.
2. Install a handle onto each handwheel, using a
14mm wrench on the flat to tighten it.
3. Install hooks (W and X) with two screws and
hex nuts (SHP-2/7). Placement is personal
preference, as all legs have holes for them.
NOTE: The two larger hooks will be on the
same side, to hold the fence. The smaller hook
holds the miter gauge.
4. Mount small hook (Y) to the front, to hold
additional accessories such as arbor wrench,
push stick, riving knife, etc.
5. Tilt arbor using right handwheel, and remove
Styrofoam packing from above motor.