Filter
Top Products
12
8.3 Stand assembly
Assembly tip: A ratchet wrench with sockets and
extensions will speed assembly time.
1. Assemble stand, using Figure 8 as a guide.
Use the provided carriage bolts, flat washers
lock washers, and hex nuts (SHP-3/4/5/6).
Only make fasteners snug at this time. They
will be fully tightened later, after stand has
settled under the weight of the saw.
2. Note the orientation of the cut-out brace (P) to
the front brace with Powermatic label (R). The
cut-out brace must be to the left, to allow
protrusion of the motor.
3. When stand has been assembled, turn it over
and install the rubber foot pads (V). (Should
you ever need height adjustment on the foot
pad, loosen the two hex nuts, rotate the pad,
then retighten the hex nuts against the metal
of the stand.)
4. Turn stand right-side up. The fasteners are not
fully tight, but they should be snug enough to
withstand the weight of the saw. If the stand
needs more stability, snug fasteners a little
more.
5. The four large holes on top of the stand should
be reasonably aligned through the upper
braces for easy insertion of the screws.
Figure 8