Filter
Top Products
35
Trouble Probable Cause Remedy
Machine will not
start/restart or
repeatedly trips
circuit breaker or
blows fuses.
(continued)
Miswiring of the unit.
Double check to confirm all electrical
connections are correct. Refer to
wiring diagram on page 47 to make
any needed corrections.
Switch failure.
If the start/stop switch is suspect, you
have two options: Have a qualified
electrician test the switch for function,
or purchase a new start/stop switch
and establish if that was the problem
on change-out.
Band Saw does not
come up to speed.
Extension cord too light or too long.
Replace with adequate size and
length cord.
Low current. Contact a qualified electrician.
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com).
Having the Model Number and Serial Number of your machine available when you call will allow us to
serve you quickly and accurately.