Filter
Top Products
41
Changing Batteries
WARNING: To reduce the risk of
injury from unexpected starting,
unplug the saw whenever you
are removing or installing the
blade.
1. Remove the Exactline™ Laser System
from the saw.
2. Remove the two Phillips screws on the
back side of the laser system and take
off the back cover.
3. Remove the three batteries with a non-
conductive device (toothpick).
4. Use a soft paintbrush to gently and
carefully clean all sawdust from the
laser system.
5. Insert the new batteries. Replacement
batteries must have a rating of 1.5 volt
and 100 mah (milliampere hour) mini-
mum. Number 76 series or equivalent.
DANGER:
• Laser radiation when open
and interlock defeated.
• Do not attempt to activate the
laser.
• Avoid direct eye contact.
• The laser is activated by
means of a centrifugal switch
only while the saw motor is
running and the laser system
is mounted on the saw.
6.Replace the back cover and secure
with two Phillips screws.
Screws
Aperature
Laser Guide
Cover
Key
Key Slot
Batteries
Negative (-)
Aperature
Laser Guide
Support