Filter
Top Products
9
Revolutions Per Minute (RPM)
The number of turns completed by a spin-
ning object in one minute.
Sawblade Path
The area of the workpiece or table top
directly in line with either the travel of the
blade or the part of the workpiece which
will be, or has been, cut by the blade.
Set
The distance that the tip of the sawblade
tooth is bent (or set) outward from the
face of the blade.
Workpiece
The item on which the cutting operation is
being performed. The surfaces of a work-
piece are commonly referred to as faces,
ends, and edges.
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
WARNING: To reduce the risk of
electrical hazards, fire hazards
or damage to the tool, use
proper circuit protection. Your
tool is wired at the factory for
operation using the voltage
shown. Connect tool to a power
line with the appropriate voltage
and a 15-amp branch circuit.
Use a 15-amp time delay type
fuse or circuit breaker. To
reduce the risk of shock or fire,
if power cord is worn or cut, or
damaged in any way, have it
replaced immediately.
The A-C motor used on this tool is a non-
reversible universal type, having the fol-
lowing specifications:
General Electrical Connections
DANGER: To reduce the risk of
electrocution:
1.Use only identical replacement
parts when servicing. Servic-
ing should be performed by a
qualified service technician.
2.Do not use in rain or where
floor is wet.
WARNING Do not permit fingers
to touch the terminals of plug
when installing or removing the
plug to or from the outlet.
If power cord is cut, or damaged in any
way, have it replaced immediately.
110-120 Volt, 60 Hz. Tool Information
Double Insulated
The miter saw is double insulated to pro-
vide a double layer of insulation between
you and the tool’s electrical system. All
exposed metal parts are isolated from the
internal metal motor components with
protecting insulation.
Face
Edge
End
Voltage 120
Amperes 15
Hertz (Cycles) 60
Phase Single
RPM 4000
Shaft Rotation Clockwise
Brake Automatic