Ryobi BT3100-1 Saw User Manual


 
Page 25
OPERATION
TO CHECK, REPLACE OR ADJUST THE RIVING
KNIFE AND BLADE GUARD ASSEMBLY
The riving knife is mounted between several shims that can
be relocated as needed to center the knife behind the blade.
It is held in place by two bolts and hex nuts at its base. The
bolts are set in slots that permit front-to-back adjustment.
WARNING:
Failure to turn the table saw off, remove the switch key,
and unplug the saw before servicing or working on it could
result in accidental starting causing possible serious
injury.
Lower the blade.
Remove the throat plate.
Raise the saw blade by pushing the bevel locking lever to
the left and rotating the blade adjustment handle clockwise.
With blade guard up, make sure the riving knife is placed
at least 1/8 in. from the outer points of the blade.
See
Figure 29.
Then make sure it is centered within the width
of the blade.
See Figure 30.
If either placement is wrong,
adjust with the following steps.
Put the saw in angle mode by moving the bevel locking
lever to the right. Slowly turn the blade adjusting handle
until the bevel indicator is at a 30˚ angle. Lock the angle
by holding the blade adjusting handle with one hand and
returning the bevel locking lever to the left with the other.
With the box end of the small hex key, remove the two
nuts at the base of the riving knife. Remove the riving
knife/guard assembly.
Rearrange the riving knife between the shims to achieve
the correct centering.
WARNING:
Properly align riving knife. Improperly aligned riving knife
can cause blade to bind which will increase risk of
kickback.
Adjust the riving knife on the bolts front-to-back as needed
to place the riving knife approximately 1/8 in. from the
blade’s outer points. Put the nuts back on and tighten.
Bring the blade back to the desired angle and height.
Lower the blade, insert the throat plate, then securely
tighten the throat plate screw.
Fig. 30
BLADE
GUARD
Fig. 29
Fig. 28
RIVING KNIFE BLADE
THROAT PLATE
RIVING KNIFE
BLADE
1/8 INCH
MOUNTING
PLATE
HEX NUTS
SHIMS
RIVING
KNIFE