Filter
Top Products
TiLT MECHANISM
Lower blade to 2 inches or closer to the table top
before tilting blade. Failure to do this may result in
damage to your saw.
The handwheel should turn freely without binding.
The turn ing action can be adjusted by tightening or
loosening the screws in the bearing retainer.
NOTE: Tilt Handwheel must be removed to adjust.
When adjusting the screws in the bearing retainer
using a screwdriver, hold the nut inside using a 3/8
in. wrench.
TILT HANDWHEEL
_J
ADJUST THESE
TWO SCREWS
MOUNTING THE MOTOR
1. CHECK MOTOR ROTATION
A. The motor must rotate COUNTER--
CLOCKWISE when viewed from the shaft end.
B. MAKE SURE "'KEY" IS REMOVED FROM
SHAFT,
C. Place the motor on your workbench or on the
floor.
D. Plug the cord into a properly grounded outlet
(See "Motor Specifications and Electrical
Requirements" Section.) Notice the rotation
of the shaft. If it is not turning
COUNTERCLOCKWISE, do not continue
assembly, Contact your nearest Sears Store or
Service Center.
E. Remove plug from outlet.
5/8 INCH
DIAMETER SHAFT
(f
_,._ _"_" KEY
COUNTER-CLOCKWISE
ROTATION
14