Filter
Top Products
LUBRiCATiON
The following parts should be oiled occasionally
with SAE No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
2. Elevation screw threads and pivot nut. (First
Clean with Craftsman Gum & Pitch Remover.)
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge
and rip fence.
LUBRICATION OF FLEXIBLE SHAFT
Flexible shafts do require ;)eriodic lubrication
because the core acts as a screw conveyor which
will ;>umpthe lubrication to one end of the shaft over
an extended period of operation. The frequency of
lubrication depenes on how the saw is used. When
the saw operates continuously for long periods of
time a lubrication schedule should be developed.
The time period may be every 80 or 100 hours. An
indication that the shaft needs lubrication is when it
becomes noisy. Conversely, when the saw has
limited and infreauent use, the grease will
GUAR__
]1_ BEARING POINTS
eventually age and harden so that it witl not prov | €
an adequate oil film between the core and cas_r
liner and must be replaced.
LUBRICATmON PROCEDURES
1 Remove the core from the casing, clean the co
by washing with kerosene or an approve
solvent.
2. Dry the core.
3. Inspect the core for worn or broken wires, if co
is damaged, it should be replaced.
4. "Butter" the entire length of the core with a goc
grade of general purpose bearing grease witf _
minimum operating temperature of-40°F a_
reassemble in casing. DO NOT force 'the grea
into the casing with a grease gun. Too mLJ,
grease wil affect shaft life because it makes t
core work ha rder.
BEARING POINTS
RECOMMENDED ACCESSORIES
ITEM CAT. NO. ITEM CAT. IN
Steel Stand ........................... 9-22214 7 In. Dia. Adjustable Dado Head
Caster Sets ................. 9-22222 or 9-22221 9-3261 - 9-3262 - 9-3,_
Solid Table Extension ................. 9-29957 7 In, Dia. Dado Head ..................... 9-31_
7 In. Molding Head Set .................. 9-3217 Sending Wheel ....................... 9-22-_
7 In. Molding Head Set .................. 9-3218 Miter-Gauge StOp Rods ............... 9-29S
7 In. Molding Head ...................... 9-32t4 Miter-Gauge Hold-Down Clamp ....... 9-29_
Molding/Dado Insert for 7 in. Taper Jig ............................... 9-3:
Dia. Molding or Dado Head .......... 9-22271 Universal Jig ........................... 9-3:
Work Light ............................. 9-2480 Powe Tool Know How Handbook
Sawdust Collection System ............ 9-24242 Table Saw ............................ 9-_€
2 "
in' " with 5/8" Bore See Catalog Cast Iron Extension, 12 x 27 Inches .... 9- _=
,v Dia. Sawblades
Work Light ............................. 9-2481 Rip Fence Bar ................... 9"2°J_"
Table Extension Kit ................... 9-2_"
39