Filter
Top Products
3, The rip fence must be PARALLEL with the
sawblade and miter Gauge grooves Move
fence until it is along side of groove. E)o NOT
LOCK IT. It sPiou/d be parallel to groove, If it rs
not;
A. Loosen the two "Hex Head Screws."
B. Hold fence head tightly against bar.. move end
of fence so that it is parallel with groove.
C. Alternately tighten the screws,
HEX SCREWS
FENCE HEAD
\
ADJUSTING RiP SCALE iNDiCATOR
1. Turn ELEVATION HANDWHEEL clockwise until
blade is up as high as it will go.
IMPORTANT: BLADE must be SQUARE (90° ) to
TABLE, in order to ALIGN rip fence,
2. Using a rule, position fence on right side of
sawblade 2 in. from the sides of the teeth...
tighten lock handle,
3. Loosen screw holding the indicator.., adjust so
that it points to "2" on the rip scale.., tighten
screw.
NOTE: If you cannot adjust indicator so that it
poin ts to "2", loosen the screws holding the front
guide bar and move the guide bar.
\
\
iNSTALLING BLADE GUARD
1. From Among the loose parts find:
4 Truss Head Screws 1/4-20 x 3/4 in. long
2 Hex Socket Setscrews 1/4-20 x 1 in. long
4 Washers 17/64 x 5/8 x 1/32
6 Lockwashers 1/4 in. External Type
(approx, die. of hole 1/4 in.)
2 Hex Head Nuts 1/4-20
{approx. die. of hole 1/4 in.)
2 Wing Nuts 1/4-20
(aprox, dia. of hole 1/4 in.)
1 Spreader Support
1 Plate Nut
1 Spreader Clamp
1 Spreader Bracket
SPREADER SUPPORT
PLATE
NUT
SPREAOER CLAMP
NUT
FLAT WASHER
17_41N
EXT. IN IN.
HEX NUT
/
FLAT WASHER
17/64 IN.HOLE
EXT. 1/4 IN.
HEX NUT
EXT. 1/4 IN.
FLAT WASHER
IN. HOLE
EXT, !/4 tN.
NUT
,OCKET HEAD SETSCREW
1 If_. LONG
23