Filter
Top Products
12. Raise blade all the way up.
13. Carefully move fence against blade.
14. Move front bar until "0" mark on rip scale is
approximately in line with indicator.
15. Move FRONT bar upwards until fence is
approximately 1/32 in. above table.., tighten
screw at left end of bar.
NOTE: Fold a piece of newspaper making 8
thicknesses and place between rip fence and
table to act as a spacer. This will ho_d the fence
off of the table approx. 1/32 in.
16. Adjust rear bar so that the fence is
approximately 1/32 in. above table.., make sure
it is square with fence guide bar rod.., tighten
screw at end of bar.
17. Be sure top surface of extension is PARALLEL
to top surface of rear guide bar.
8 THICKNESSES
OF PAPER
18. Move fence to RIGHT edge of table.., make
sure it is approx. 1/32 in. above table at front and
rear and tighten screws.
8THICKNESSES
OF PAPER
ALIGNING RIP FENCE "_--_
The fence should side easily along the bars and
always remain in alignment (para el to sawblade
and miter gauge grooves).
The alignment is rnaintained by a spring underneath
the rip fence which bears against the front guide
bar.
TO move the fence, loosen the lock handle and
grasp the fence with one hand at the front.
/