Filter
Top Products
5. Turn front bar end for end and insert bo}ts
through holes in middle and on right sides of
front of saw table as illustrated . . . install
Iockwashers and nuts. DON'T SCREW NUTS
ON ALL THE WAY. just get them started on the
screws.
6. Insert 1 in. long screws in SECOND and
FOURTH or FIFTH holes of rear bar and attach
to table the same way as front bar.
7. Insert ends of FENCE GUIDE BAR ROD
through holes in bars as illustrated.
NOTE; The ends of the RODare notthreaded,.
the SELF THREADING NUTS will cut threads
on the rod as they are screwed on. Just start nuts
onto ends of rod.
4TH OR 5TH
_" SELF-THREADING NUT HOLE
FENCE GUIDE
BAR ROD
2ND HOLE
8. Hold rod with one hand and with a 1/2 in. wrench
or pliers start screwing on ONE of the nuts only
A TURN OR TWO... screw on other nut the
same way.
9. Using TWO 1/2 in, wrenches or pliers tighten
both of the nuts,
.f
/
10. Slide the bars sothat screws are in the M I DDLE
of the slotted holes,
11. Lift rip fence lock lever and position rip fence
over miter gauge groove, holding up the rear
end while engaging front end witl-;bar.., lower
fence onto table,