Filter
Top Products
14. With end of LARGE FERRULE inserted into
recess in motor end cap tighten 2 Hex Head nuts
on shaft brackets. LARGE FERRULE must be
pushed against the motor end ca p as far as it wil I
go. Tighten nuts but do not OVERTIGHTEN.
The shaft brackets hold the LARGE FERRULE in
place. Nuts should be securely tightened to
prevent movement. Overtightening may cause
damage to the LARGE FERRULE.
IMPORTANT: The LARGE FERRULE should be
centered over the MOTOR CONNECTOR (now
located Inside of LARGE FERRULE), to prevent
the MOTOR CONNECTOR from contacting the
LARGE FERRULE.
15. Carefully turn saw blade by hand to make sure
MOTOR CONNECTOR does not hit LARGE
FERRULE.-If they are .in contact, it will cause a
noise and cause resistance to rotation,
16. If the MOTOR CONNECTOR does hit the
LARGE FERRULE loosen the nuts holding the
shaft brackets to the saw base, and the nuts
holding the LARGE FERRULE in the shaft
brackets. Adjust the brackets and the LARGE
FERRULE until the LARGE FERRULE is
centered and is not hit by the MOTOR
CONNECTOR.
NOTE: It may be necessary to raise or lower
motor on motor mount slightly. Be sure to
reposition shaft brackets as required.
17. Tighten nuts.
/
z
LARGE
FERRULE
__ BEAD ON FERRULE MUST
CONTACT MOTOR END CAP
MOTOR
CONNECTOR
MOVE BRACKETS UP OR
DOWN SO THAT MOTOR
CONNECTOR INSIDE DOES
NOT HIT FERRULE.
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
From among the loose parts find the following
hardware: ((_uantity indicated is for 2 extensions)
HARDWARE FOR INSTALLING
EXTENSIONS TO SAW TABLE
Ref.
No. Description Qty.
1 Hex Hd. Screw, 5/16-18 x 1-1/4 .... .. 8
2 Flat Washer (Dia. of Hole 11/32) ..... 8
3 External Lockwasher, 5/16_ ........... 8