Filter
Top Products
ASSEMBLY
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model
113.241691, From among the loose parts, find the
following Hardware:
24 Truss Head Screws, 1/4 - 20 x 5/8 in. long (top
of screw is rounded)
24 Lockwashers. 1/4 in. External Type (approx.
dia. of hole 1/4 in.)
24 Hex Nuts, 1/4 - 20 (approx, dia. of hole 1/4 in.)
8 Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown ...
1. Insert the Truss Head Screws through the holes
in the legs, then through the holes in the
stiffeners. MAKE SURE THE SCREWS GO
THROUGH THE HOLES IN THE SIDE
STIFFENERS MARKED "X".
2. Install the Iockwashers,.. screw on the nuts but
Do Not tighten until completely assembled.
3, Install leveling feet.
END
STIFFENER"
o
ASSEMBLE SCREWS
J" THROUGH HOLES
-/f MARKED"X"
7
"_,SIDE STIFFENER
_21N. HEX NUTS
MOUNTING SAW
1. From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16 - 18 x 1-1/4 in. long.
4 Hex Nuts, 5/16 - 18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx,
dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
2. Place saw on legs so that holes in bottom of saw
line up with holes in top of legs.
/
/
/
3, install screws, washers, Iockwashers and nuts as
shown.
SAW BASE
HEX HEAD SCREW _,_l I
FLAT WASHER
END ;
STIFFENER-'I ' I