Shindaiwa 4 Cycle Diesel Engine Welder User Manual


 
14
6-4 Checking Fuel, Engine Oil and Water Leakage
Caution : Fire
z Always wipe any drip of Diesel fuel or oil. Do not use this equipment when a leak is found.
Repair the equipment before use.
Be sure to check for any fuel leak at the hose connection, and oil and coolant/water by opening
side doors. When checking for any fuel leak, open a fuel lever and be sure to close the fuel lever
after checking.
6-5 Checking Battery
Caution : Injuries to eyes and skin
z Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or clothing. If the acid
comes in contact, especially with eyes, flush with a lot of water, and contact your physician
immediately.
Caution : Explosion
z When the liquid level is below the LOWER level, never use the equipment nor recharge the
battery.
z Battery may emit some combustible gas, so keep it away from fire and sparks.
Check the fluid level. If the level is near or lower than the
LOWER level, add distilled water until the fluid level reaches
the UPPER level.
Make sure that the battery cables are firmly secured to the
posts. Tighten the clamps if necessary.
<Caution>
z Check the hydrometer of the battery fluid. If it falls below 1.23, the battery requires recharg-
ing. Please consult with our authorized distributor or our engineering section.
Replacing battery
Remove the clamp and cable from negative (-) post in
the battery. (Remove always negative side first)
Remove the hold-down clamp from the battery.
Remove the clamp and cable from positive (+) post in
the battery.
Remove the battery from the seat.
Reinstall a new battery in the reverse order. (Install always the cable to the positive (+) post
in the new battery first.)
<Caution>
z Use the following battery.
46B24L
7. Operation
7-1 Initializing/Preparation
UPPER
LEVEL
TERMINAL
LOWER
LEVEL
+ TERMINAL
- TERMINAL
BATTERY
HOLD-DOWN
CLAMP
INS-CAP