Shindaiwa DGW310DMC Welder User Manual


 
12
Caution: Burns
Do not touch the engine and muffler during operation and immediately after stopping it, for the
temperature can reach extremely high
When checking engine oil or changing oil, always stop the engine, and wait until the engine
cools down. If you open either the oil gauge or the oil plug during operation, hot oil may cause
some injuries.
When the oil pressure drops during operation, the monitor lamp flashes and the automatic shutdown is
engaged. When this occurs, check the engine oil level and replenish the maximum level if needed.
Caution
The monitor cannot detect the degradation of engine oil. Please check engine oil periodically and replenish if
needed.
(Refer to 11. Checking and Maintenance )
Check fuse next, when the abnormality other than Water Temp , Charge or Oil Pressure is detected.
If a fuse is burnet, consult with our authorized distributor or our service section, because there may be an
abnormality of electric/electronic parts or wiring and repairing may be required.
(Refer to 4. Parts )
5-5. Remote Control Box (Option)
You can make remote control by connecting our remote control box
How to connect remote control box
1. Remove the remote control
Receptacle cover.
DMC: M5 Screw x 2 pcs
MC: M4 Screw x 2 pcs
cover
screw
cover
screw