Filter
Top Products
27
9-2. Output Limitation
Please refer to the table below, because electric tools and home appliances cannot be judged only by the
rated.
The rated output or the power consumption due to the efficiency and character of components.
Applicable Load (For reference only)
Capacity(kW)
1-P 100/110V
1-P 200/220V
3-P 200/
220V
Loads
Receptacle
1pce
Terminal
1 set
Terminal
receptacle
total
Terminal
1 set
Total 3 terminal
set
Terminal
Electric Bulb, Heater, etc.
1.5 3.0 6.0 6.0 8.0 ―
Electric Tools, etc. (Series
motor)
0.7 1.5 3.0 3.0 4.0 ―
Mercury Lamp (high power
factor type)
0.6 1.2 2.4 2.4 3.2 ―
Submersible Pump,
Compressor, etc. (induction
motor)
0.6 1.2 2.4 2.4 3.2 4.0
Series Motor Motor with brush
Induction Motor Brushless Motor
The value described is OUTPUT for induction motor load and
POWER CONSUMPTION for the other equipment.
Caution
● Be sure to use the frequency designated in the equipment incorporated in mercury
bulb or induction motor.
● The load incorporated in motor may require bigger power than the rated power
consumption.
So, consult with our authorized distributor or our engineering section to clarify.
● When connection to use 2 or more sets, start the load one by one, not to start them simultaneously.
● When starting a mercury bulb ON again, wait for about 15 minutes until it cools down.