Shindaiwa DGW310DMC Welder User Manual


 
18
Mixture ratio of the coolant should be 30%-45% depending on the ambient temperature.
Replace LLC at every year or 2000 hours.
Recommended LLC concentration (for reference only)
Lowest Temp. -15 -20 -30
Mixture Ratio 30% 35% 45%
6-3 Fuel
Caution: Fire
Always wipe any drip of fuel. Do not use the equipment when any leak is found.
Repair the equipment before use.
Check the fuel level and add the fuel if it is necessary.
Caution
Use Diesel Fuel JIS No.2 in the event ambient temperature down to -5
In colder area, use JIS No.3 (down
To -15
.)
or JIS No. Special 3
(down to -25 )
Always use fuel strainer in the
fuel inlet.
Fill the fuel tank slightly less
than the FULL tank.
6-4.Fuel, Engine Oil and Water Leakage
Caution: Fire
Do not use the equipment when any leak is found. Repair the equipment before use.
Be sure to check any leakage for fuel, oil and coolant/water at the hose connections by opening the side
doors. Whenever checking leakage, turn the fuel lever OPEN and be sure to close the fuel lever after
checking.
Tank Cap
Strainer
Fuel Inlet