Filter
Top Products
-23-
W1668 13
1
⁄4" Oscillating Drill Press
OPERATIONS
Once assembly is complete and adjustments
are done to your satisfaction, you are ready to
start the drill press. Every time you start the
drill press, you should follow these basic
instructions.
To start the drill press, do these steps:
1. Make sure the starting switch paddle is
down for OFF.
2. Make sure all fasteners and lock handles
are tight.
3. Make sure the drill chuck key is removed.
4. Plug in the power cord.
5. Lift the ON/OFF switch to start the drill
press, and make sure that your finger is
poised over the paddle, as shown in Figure
39, just in case there is a problem.
6. Listen and observe the drill press, it should
run smoothly, with little or no vibration or
rubbing noises.
• If you hear strange or unusual noises, shut
the drill press OFF, and wait for the spin-
dle to stop moving.
7. Unplug the drill press and refer to the
“Troubleshooting” table on Page 28 to
help isolate and correct the problem
before using the drill press again.
Figure 39. Hand poised over a typical stop
switch.
WEAR safety glasses and
a respirator during drill-
ing or sanding opera-
tions. Otherwise serious
personal injury may
occur!
Keep your shop “Child
Safe.” Always remove the
switch safety key when
drill press is not in use.
Serious injury may occur.
Starting the
Drill Press
OPERATIONS