Filter
Top Products
-25-
W1668 13
1
⁄4" Oscillating Drill Press
OPERATIONS
One of the great features of the Model W1668
13
1
⁄4'' Oscillating Drill Press is its sanding capa-
bility. The drill press can be converted from
drilling operations to sanding operations in just
a few steps.
To use the oscillating feature, do these steps:
1. UNPLUG THE DRILL PRESS!
2. Remove the spindle handles.
3. Lift the belt cover and remove the round
belt located on the storage bracket under
the speed chart, as shown in Figure 43.
4. Stretch the belt onto the top groove in the
spindle and oscillating pulley, as shown in
Figure 44.
5.
Close the cover. The motor will not start
until the cover is closed.
6. Loosen the jam nut for the depth stop and
adjust both nuts until they are positioned
at the top of the depth stop rod. Tighten
the jam nut (see Figure 45).
UNPLUG the machine and
remove all handles before
using the oscillating fea-
ture. The handles swing
during operation.
Figure 45. Back-off the depth stop nuts.
Figure 44. Stretch the belt to fit on pulleys.
Using the Oscillator
ALWAYS back-off the depth stop completely
and secure the depth stop nuts before using
the oscillating feature. If the depth stop is
left adjusted for a shallow hole, or the nuts
rattle down to the stop while in operation,
the depth stop will bottom out and break
the oscillator.
NOTICE
Figure 43. Oscillator belt on storage bracket.
Belt and stor-
age bracket