Filter
Top Products
-22-
N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
FG<I8K@FEJ
;\gk_f]:lk
Maximum Depth of Cut ............... Approx. 0.016" (
1
⁄64")
The optimum depth of cut will vary based on the type of
wood, conveyor feed rate, and sandpaper grit. Attempting
to remove too much material can cause jamming, wood
burning, rapid sanding belt wear or tearing, poor finish, or
belt slippage.
Under most conditions, the sanding depth should not
exceed 0.016" for any one pass. Each full turn of the ele-
vation handwheel changes the height of the sanding belt
from the workpiece approximately 0.025", with approxi-
mately
2
⁄3 of a turn equal to the recommended 0.016"
change in depth.
When properly adjusted, the depth of cut safety bar (see
=`^li\)() is an excellent tool for setting the ]`ijkdepth
of cut. Refer to ;\gk_f]:lkJX]\kp9Xi on GX^\*, for
more information.
Position the workpiece and sanding cabinet so that the
bottom of the safety bar just touches the workpiece.
This will set the sanding belt approximately 0.016" lower
than the top surface of the workpiece. Then rotate the
handwheel one full turn clockwise to raise the sanding
belt high enough so that the first pass will take off any
high spots. For additional passes, rotate the handwheel
2
⁄3 of a turn counterclockwise to lower the sanding belt
approximately 0.016".
8dg\iX^\CfX[D\k\i
The amperage load meter on the control panel (see
=`^li\))) shows how much amperage the sanding motor
is drawing for the operation, or how hard the machine
is working. If the depth of cut or the conveyor feed rate
becomes too great, the sanding motor will draw an exces-
sive amount of current (amperage), which may trip the
circuit breaker or damage the machine.
Always keep your depth of cut within recommended spec-
ifications and monitor the conveyor feed rate so that the
amperage load meter stays in the green SAFE range dur-
ing the entire operation.
=`^li\)(% Depth of cut safety bar.
Safety Bar
Elevation
Handwheel
Elevation
Scale
NOTICE
;F EFK MF@; K?< N8II8EKP B\\g
k_\ Xdg\iX^\ cfX[ d\k\i n`k_`e k_\
^i\\eJ8=<iXe^\j_fnefek_\Xdg\i$
X^\cfX[Z_Xik%@]pflfg\iXk\k_\jXe[$
\iXYfm\(+8fi`ek_\i\[N8IE@E>
iXe^\#ZXgXZ`kfifi dfkfi ]X`cli\ dXp
fZZli Xe[ n`cc efk Y\ Zfm\i\[ le[\i
nXiiXekp%
=`^li\))% Amperage load chart and
meter.
Amperage Load Chart
Amperage Load Meter