Filter
Top Products
-25-
N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
FG<I8K@FEJ
JXe[`e^Fg\iXk`fe
DO NOT sand more than one board at
a time side-by-side. Minor variations
in workpiece thickness can cause one
board to be propelled into the operator
at a high rate of speed by the sanding
belt and could result in serious personal
injury.
Kfg\i]fidXkpg`ZXcjXe[`e^fg\iXk`fe#]fccfnk_\j\
jk\gj1
(% Read and follow the safety instructions at the begin-
ning of the manual, and make sure the machine is
set up properly before starting the sander.
)% Connect the source of compressed air to the sander
and adjust the air regulator to 57–60 PSI.
*% Make sure the workpiece is clean and free of any
defects or foreign materials that might cause kick-
back or damage to the sander.
+% Start the dust collection system.
,% Use the elevation handwheel to set the correct sand-
ing depth of cut for the first pass (refer to ;\gk_f]
:lk on GX^\)) for detailed instructions).
Efk\1>\e\iXccp#k_\]`ijkgXjji\dfm\jk_\_`^_
jgfkj%
-% Turn the sanding motor FE.
.% Turn the conveyor FE and correctly adjust the
conveyor feed rate for your operation (refer to
:fem\pfi=\\[IXk\on GX^\)( for detailed
instructions).
/% Stand to the side of the sanding path, then firmly
hold the workpiece and ease it into the sander at
the same feed rate as the conveyor.
0% While standing to the side of the sanding path, let
the conveyor feed the workpiece out of the sander
and into your hands.
('% For additional passes, use the elevation handwheel
to lower the sanding drum to the correct sanding
depth of cut for your operation, which should not
exceed 0.016" (
1
⁄16").
Efk\1=finfibg`\Z\jn`[\ik_Xe(/Xe[le[\i*-#
ifkXk\k_\jkfZb(/'_fi`qfekXccpkfjXe[k_\fk_\i
_Xc]%N\i\Zfdd\e[fm\icXgg`e^k_\jXe[`e^Xi\Xj
]fi^ff[i\jlckj%