Woodstock W1813 Sander User Manual


  Open as PDF
of 56
 
-30-
N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
J<IM@:<
*% Turn both adjustment bolts clockwise one full turn at
a time until there is an approximate
3
⁄4" hanging gap
on the underside of the conveyor belt.
+% Take another reading of the reference measurement
on both sides of the conveyor and make sure they
are the same.
— If the belt starts to track to one side or the other
when in operation, immediately turn the conveyor
F==Xe[g\i]fidk_\kiXZb`e^gifZ\[li\Y\cfn%
:fem\pfi9\ckKiXZb`e^
If the conveyor belt tracks to either side, the belt could
become damaged and you will have to replace it.
Adjusting conveyor belt tracking is a balancing process
that takes patience and trial-and-error. You must tighten
the adjusting bolt on the side the belt is tracking toward
to make the belt move to the middle of the rollers, then
loosen that same adjusting bolt to make the conveyor belt
stay centered.
KffcjE\\[\[ Hkp
Wrench 10mm ...................................................1
KfX[aljkk_\Zfem\pfiY\ckkiXZb`e^#[fk_\j\jk\gj1
(% Make sure the conveyor belt is properly tensioned
(refer to :fem\pfi9\ckK\ej`fe`e^on GX^\)0 for
detailed instructions).
)% Turn the conveyor FE and set it to a slow feed rate,
then watch it track.
*% Determine which side the conveyor belt is tracking
toward, then tighten the adjustment bolt on that
side until the belt begins to track in the opposite
direction.
Efk\1KiXZb`e^Z_Xe^\jdXpkXb\XZflgc\f]d`e$
lk\jY\]fi\k_\pXi\efk`Z\XYc\%
+% When the conveyor belt is near the middle of the
rollers, loosen the same adjustment bolt until the
belt stops moving to the side and tracks straight and
centered.
— If the belt tracks too far to the other side, tighten
the adjustment bolt as necessary to bring it back
toward the middle, then repeat Jk\gj)Æ+until
the tracking is correct.
The conveyor roller assemblies and belt
pose an entanglement hazard. Take
extra care when performing the con-
veyor belt tensioning or tracking proce-
dures to keep hands, fingers, and cloth-
ing away from the moving parts of the
conveyor assembly.
 previous next