Filter
Top Products
-16 -
For Machines Mfg. Since 8/09
Model SB1019
PREPARATION
Figure 11. Adjusting downfeed stop bolt.
2. Adjust the downfeed stop bolt and jam nut
shown in Figure 11 with a 14mm wrench, so
the bandsaw blade teeth are just below the
table surface when the cut is complete.
Downfeed Stop Bolt
Machine Setup
To ensure that your bandsaw arrives without
damage to the hinge system, a shipping bracket
was installed. After removing the shipping
bracket, you will have to adjust the downfeed
stop bolt.
To set up the machine:
1. Remove the shipping strap hex bolt and
strap as shown in Figure 10. Keep this
shipping bracket in case you transport or
ship the bandsaw in the future.
Figure 10. Removal of the shipping bracket.