Filter
Top Products
-18-
For Machines Mfg. Since 8/09
Model SB1019
PREPARATION
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note: Refer to Troubleshooting on Page 35
for solutions to common problems that may
occur with metal-cutting bandsaws. If you need
additional help, contact our Tech Support at
(360) 734-1540.
To test run your machine:
1. Read and follow the safety instructions at
the beginning of the manual, take the re-
quired safety precautions, and make sure the
machine is assembled set up properly.
2. Clear away all tools and objects used during
assembly and preparation.
3. Open the downfeed valve (Figure 13) and
allow the headstock to travel all the way
down. If the blade contacts the machine
base, adjust the downfeed stop bolt.
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before your machine was shipped.
If you find that the adjustments are not set
according to the procedures in this manual or
your personal preferences, re-adjust them.
• Blade Tracking ..................................Page 38
• BladeGuideBearings .......................Page 39
• Squaring the Blade ...........................Page 39
4. Connect the machine to the power source.
5. Put on safety glasses and secure loose
clothing or long hair.
6. Lift the headstock by the handle to the
raised position, then close the downfeed
valve to prevent it from lowering.
7. Start the bandsaw while keeping your
finger near the ON/OFF switch at all times
during the test run. The bandsaw should run
smoothly with little or no vibration.
— If you suspect any problems, immediately
turn the bandsaw OFF, disconnect it from
power, and correct the problem before
continuing.
— If you need any help with your bandsaw
call our Tech Support at (360) 734-1540.
Figure 13. Downfeed valve.
Downfeed
Valve