A SERVICE OF

logo

Open as PDF
next previous
Section 1 – Introduction Installing In-Sight™ 4000 Series Vision Sensors
4
To install multiple In-Sight 4000 sensors onto a standalone In-Sight network, use an
Ethernet switch between the In-Sight 4000 sensors and the In-Sight PC Host or
In-Sight 3000 processor. Make all connections via standard, straight-pinned CAT5
cable (Figure 1-3 and Figure 1-4).
Figure 1-3: Multiple In-Sight 4000 Sensors – In-Sight PC Host Network
Figure 1-4: Multiple In-Sight 4000 Sensors – In-Sight 3000 Network
The number of In-Sight sensors and In-Sight PC Hosts that may be installed on a
standalone In-Sight network are limited only by the number of ports available on the
Ethernet switch. To expand a standalone In-Sight network, add Ethernet switches as
needed to increase the number of available network ports.