Installing In-Sight™ 4000 Series Vision Sensors Appendix A
41
8 Configure the IP Address and Subnet Mask.
9 Highlight TCP/IP Protocol in the Protocols tab and click Properties to open the
Microsoft TCP/IP Properties dialog (Figure A-3):
Figure A-3: Microsoft TCP/IP Properties Dialog
10 Click the Specify an IP address radio button. The IP Address and Subnet Mask
fields, which are grayed-out when DHCP is enabled, become active.
11 Enter an appropriate Subnet Mask. The Subnet Mask defines which part of the
In-Sight 4000’s IP Address refers to the network and which part refers to the host.
The network part of the IP address is the same for all hosts on the same subnet,
and the remainder is unique to each host. The default Subnet Mask setting of
255.255.255.0 is usually appropriate.
12 Click OK twice, then restart Windows if prompted to do so.
